Windows 10: PC turns on and off continuously with a gap of 3 second

I was having bsod quiet frequently untill yesterday when my pc won't even startno display output. Most of the bsod were in ntoskrnl.exe and the error being SYSTEM SERVICE EXCEPTION or MEMORY MANAGEMENT. Now whenever I push the power button the pc turns on only fans rotate then after 3-5 second it turns off then again turns on and the again off. This cycle continuous infinitely.

My PC is HP 110-016in updated to Windows 10 2004 update

:)

 

Surface Pro 3 won't turn on

Hi,

Thank you for posting the query on Microsoft Community.

We understand how you feel about the situation. We're sorry for the trouble.

I suggest you to follow the steps below and check, if it helps:

If you still have the device, please let the device charge at least 2 hours and do the 2-button shutdown one more time to see if you can turn on the device.

• A 2-button shutdown
  • Press and hold the power button on your Surface for 30 seconds.
  • Press and hold the Volume-up button and the
    Power button on your Surface at the same time for at least 15 seconds, and then release both. The screen may flash the Surface logo, but continue holding the buttons down for at least 15 seconds.
  • After you release the buttons, wait 10 seconds.
  • Press and release the power button on your Surface to turn it back on.

Hope this helps. If the issue remains unresolved, please get back to us and we would be happy to help

 

PC Build Steps

Ok just because I like steps i am going to create some steps. Please give me the stamp of approval/disapproval

• Install system in case
  • Remember to connect SSD and optical to same SATA ports on motherboard
• Turn on PC
• setup HDD
• run blend test in prime95 for 30-60 min
  • run realtemp at the same time

• While in Prime95 test
  • if CPU goes above 70c in RealTemp, I have a leaky CPU
  • if my system locks up or blue screens, there is an instability in the system somewhere
  • if my system does not lock up or blue screen, my CPU is not damaged and I am in the clear!

What do you guys think??

 

PC shuts down after a second when turned on

Could be a bad motherboard, but try these steps and see how far you can get.

Strip it down and then add components back, one at a time, to try and isolate the offending component.

Turn the power off and unplug the power cord.

Disconnect everything externally connected except the mouse and keyboard (printers, USB devices). If you are not using a wired mouse and keyboard see if you can borrow one.

• Disconnect the power and data cables from all the drives inside the computer (Hard drives, DVD/CD drives).
• Remove all the cards installed in the PCI slots including the video card.
• Remove all the RAM sticks (same rules as above).

Now connect the power cord and turn the PC on.

• The motherboard should start beeping. You should get a beep code that tells you there is no memory. This is good, it means the processor is functioning and the motherboard is good so far.

• Now add one stick of memory in Slot A1 and power on. I guess your CPU has integrated graphics. Do you get more beeping at this point?

If you get no video then switch the one memory stick installed for another one and test.

Continue adding components one at a time.

If at any point the PC fails, the last component added was the problem one.

If you removed everything and there is only the motherboard (with integrated video), processor, and power supply to contend with and it does not POST or show anything on the screen, then the problem is one of those three.

If you have tested by using another power supply then you are down to two. CPUs rarely fail, so motherboard is the most likely guess.

Try to clear CMOS or replace the motherboard battery as a last ditch effort. Both long shots, but what do you have to lose at this point.