Windows 10: “Plugged In”

Hi, So I having this problem for ages. My laptop only says “Plugged-in” I do not know what it means and my battery drains. Recently, I went to Curry’s PC World UK to get the pin of my DC Port ,which was apparently broken, to get fixed. Today, I had got it back and I still get this after hovering over the battery icon. What is the reason to this? Is it a software or physical problem?

:)

 

Why exactly is ATi considered be better at HDMI?

I plug my HDMI cable into the card, then into my TV. Those are the steps that I have to do. All the steps you list make absolutely no sense to me.

 

about plug-in or plug-out with AC adapter

I have done all of the above and when I plug my computer in with a fully charged battery the screen still goes black - I am on Windows 10 and my computer is 3 days old - HP Pavillion Laptop - I know there has got to be an easy answer for this Problem - Like
a setting somewhere, but I am used to using my computer plugged in at all times and I think that it is stupid that I have to take out the battery to do this??? Any more suggestions??? :-(

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".