Windows 10: Port Triggering

Hello,
So I'm attempting to play an online game with my two children and I've been experiencing some latency issues as have they. I wanted to setup Port Triggering as I've noticed when attempting to do the Port Forwarding it's only opening the ports for my computer's IP address instead of any/all devices connected to the router.
I have the Cisco DPC3941T which is the Xfinity version. One of the ports to be opened is TCP 7000. I've put 7000 in both Trigger and Target Ports and it says conflicting. I did read that the Trigger and Target Ports need to be different but I don't understand then how to setup Port Triggering with the one port number which is 7000. So what should my Trigger Port be? 7000? And then what should the Target Port be?

:)

 

USB Port Oddities


Ok, let's see it with pictures step-by-step. First right-click on the USB device and select Update driver software:





Then select Browse my computer for driver software (LAST option) :





The select Let me pick from a list of device drivers on my computer (LAST option) :





Then select the standard driver from the list and click next:





Click next/OK as required to complete installation. Repeat the steps for all Intel USB devices. Finally click on each USB root device and press DEL to delete it, reply YES when asked. After deleting all USB root devices restart the computer.

I hope this is detailed enough...

 

Port is being blocked

Hi,



Thank you for writing to Microsoft Community forums.

• Are you aware of any changes that happened on the computer prior to this issue?
  

Upon researching, this seems like an issue due to the port scan. You may want to try the steps listed below and check if it works.

• Login to your Netgear
  NX6200 Extender GUI.
  
• Click on Advanced tab and choose
  WAN Setup.
  
• Check the box for Disable Port Scan and DoS Protection.
  
• Allow it to update and check if the port is still being blocked.
  

However, if the issue persists, I suggest you to post your query in the
TechNet Forums, where we have support professionals
equipped with knowledge on port forwarding.



Regards,

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".