Windows 10: raw hard drive

hallo
I have a hard drive that was gpt ntfs used as secondary drive. (storage)
I set a wrong id for the volume and then i understand my mistake and i set again the good id (ebd0a0a2-b9e5-4433-87c0-68b6b72699c7)

But now the ntfs is shown as raw.

The check disk show:
C:\WINDOWS\system32>chkdsk D: /f /x
The type of the file system is NTFS.
The first NTFS boot sector is unreadable or corrupt.
Reading second NTFS boot sector instead.
Unable to determine volume version and state. CHKDSK aborted.

It is possible to restore it?

:)

 

Save RAW drive - Don't want data


Open Admin command prompt, then type:

1. diskpart
2. list disk ======> Take note of disk # of the RAW drive
3. select disk # ======> is the number in step 2
4. clean
5. exit

Open Disk Management and initialize it, Create Simple, format.

 

How to convert RAW partition to NTFS partition.

Thanks for your reply. Apparently the convert drive to NTFS doesn't work when the drive is RAW. After following your instructions in step 2 I get message "convert is not available for RAW drives.

Any suggestions?

 

Overclock your hard drive!!!

Heres a much easier hack that I realized quite a few years ago that really does work!

REQUIREMENTS:

• Hard drive with molex power connection.
• PSU with more than 1 strand that has molex plugs on it.
• Wire strippers, soldering iron if you're fancy, electrical tape if you're not.

STEPS:

• Take the strand of connectors from your PSU, and decide which one will be the donator for this overclocking adventure.
• Cut the yellow and orange cables, then twist them together.
• Find the power connector you've chosen as the overclocking connector, and release the orange cable from the connector. Now use your preferred method to bind them together, then place it back together.
• Plug in a drive and feel the speed!

Congratulations! You've just overclocked your hard drive!