Windows 10: Reset Display Settings

Hello, when I stack my program windows or want to see them side by side they are never even and cleanly stacked. I think I might have messed this up. How can I reset the display settings so that the windows stack and show evenly side to side.

:)

 

Display settings

Hi Julia,



To reset the settings back to default, follow these steps:

• Go to your desktop, right click and select Display Settings.
• Choose the appropriate settings from the options under Display.

Let us know if the above steps resolved the issue.

 

Display and sleep settings

Hi,

In order to help you with the issue about the display and sleep settings, kindly answer the following questions:

• Have you tried the troubleshooting steps suggested by MVP Andre Da Costa? If you did, what were the results?
  
• For us to avoid redundancy of the troubleshooting process, what were the other steps you have done to resolve the issue?
  

We look forward to your next post.

Regards.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".