Windows 10: Resetting My Pc But Need Help

Hi There


I Am Nirav.I Am Having A Windows 10 Pro 64Bit Os In My PC I Have Purchased Windows 10 Pro Key From Local Market And I Registered That Key To My PC Under Setting -->Update & Security -->Activation . It's Almost 8 To 9 Months That I Have Purchased This It's Working Fine And I Also Connect My Key To Microsoft Account.Now I Want To Re-Set My PC Due To Some Apps & Want To Reorganize My PC From Starting .


I Just Want To Ask You That If I Use Recovery Option -->Reset This PC-->Get Started --> Remove Everything That Means My Full System Get Erased And All New Windows 10 Pro With Exact That Version Will Be Installed On The Device Right??



But Now The Main Question Is Come The Question Is As You Can See That I Have Inserted My Windows 10Pro Key In The System And Connected That Key To My Microsoft Account So When The PC Is Reset Is Done And System Ask Me For Inserting Windows Key On The System So Can I Use My Microsoft Account Which Have My Previous Connected Key OF Windows 10 Pro And After Reset Am I Have To Do Disk Partition Or It Goes With Same Exact Old Disk Partition ???


While Reset This PC Am I Need Any Windows File To Insert Windows In The System Or The Reset PC Just Reset All The Things Of System And Use My Current Copy Of Windows To Be Installed On The System.


Thanks


Note--Please Help To Solve My Query And Don't Spam Here Only Moderator's And Expert Advisor Are Welcome To Solve My Query.

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

1070 Overheat Crash x(

Yes try it again... lol... we were waiting for that!

You have steps listed....try to find a another pc to try...try to reset the bios and see if that for some reason would help. But yes, try putting it back in. If not, id say rma time.

 

help to remote connect

not sure how to use both programs u 2 suggested, i need more helpful steps thanks