Windows 10: Restoring from system image backup

submitted by /u/SgtJackVisback
[link] [comments]

:)

 

Restore a System Image Backup

Hi Kirk,

One of the possible reasons why this issue occurs is when the System Image Backup that you'd like to restore is corrupted. We would like to know more about the issue so we can assist you better. Please answer the following questions:

• How did you create your system image backup?
• Can you provide us the screenshot of the exact error message?
• Is your USB device readable to other PCs?
• What are the contents of the USB device? Can you provide us the screenshot of it?

We're looking forward to your response.

 

How to restore system image backup

Ryan,

To restore from a system image by booting with an installation disk or System repair disk -

1. [Boot from the disk]
2. Select language, formats & keyboard,
3. Select Repair your computer,
4. Troubleshoot,
5. Advanced options, [and see note ***]
6. System image recovery,
7. Accept the latest image identified by the system or, if you have multiple images saved on your backup drive, use Select a image to chose the one you want.
8. The rest is entirely menu driven. Whilst there are some options that can be chosen, the defaults are normally off for all these and should be accepted.

I am not familiar with use of a Windows 10 "Recovery drive" but I would expect only the opening steps to be any different. Everything after selecting System image recovery would, I expect, be the same.

If you get any untoward events such as warnings about formatting drives, please take a photo of the screen and post it here.

If, when booting from an installation disk etc, you are interrupted by this dialog, just select No. The only time I have seen this dialog was when I was restoring a system image straight after having installed a new Windows 10 version.




*** Do be aware that your normal drive letter assignments do not [temporarily] apply when booting from an installation disk etc or using the onboard restore facility ["WRE"] so from the Advanced options you can select Command prompt then use Dir C: then Dir D: and so on commands to look at each drive in turn to figure out what each one is temporarily called [ignore the X drive, it is a virtual drive controlling the computer during this procedure]. When you have finished, type Exit to close the Command prompt and it will take you back to the Choose an option screen where you can select Troubleshoot, my step 4 above.

Denis

 

Restoring Windows 10 Image using Macrium Reflect


In addition to the above. Here's my suggestion in step by step.
I assume you have Macrium Installed in your current HD and already made a backup copy.

1. Connect your new HD via USB port and boot up.
2. Run Macrium, click on Restore tab then select the Backup Image that you made to restore
3. click on "select a different target disk" then select your new HD as destination
   
   
   
4. Proceed to restore then Shutdown and disconnect the old HD and replace with the new HD
5. Boot up with your new HD.