Windows 10: SD Card disk not shown in Task Manager Performance view

Hi all, The Performance graphical view of the task manager doesn't show the disk volume associated with my SD Card, which is drive 'D:'. The problem is the same when I'm actively using the SD Card and copying files. This disk volume is however functioning correctly (read/write files), and is displayed as should in the Windows File Explorer, in the Device Manager as a SD Card reader and as a mounted disk volume, and in the Resource Monitor, as shown in screenshots below. Any idea on how I can it also usefully appear in the Performance view of the Task Manager ? Thanks for your advice ! PS: the SD Card is embedded in an HP EliteBook 850 G4 laptop, runnning Windows 10 version 1909 (build 18363).

:)

 

SD Card disk not shown in Task Manager Performance view

Hi all,

The Performance graphical view of the task manager doesn't show the disk volume associated with my SD Card, which is drive 'D:'. The problem is the same when I'm actively using the SD Card and copying files.





This disk volume is however functioning correctly (read/write files), and is displayed as should in the Windows File Explorer, in the Device Manager as a SD Card reader and as a mounted disk volume, and in the Resource Monitor, as shown in screenshots below.












Any idea on how I can it also usefully appear in the Performance view of the Task Manager ?
Thanks for your advice !

PS: the SD Card is embedded in an HP EliteBook 850 G4 laptop, runnning Windows 10 version 1909 (build 18363).

 

SD card failure

Hi Andrew,

I would need to ask few questions so I can isolate your concern properly. Kindly answer the following:

• Did you get a specific error message?
• What are the troubleshooting steps you have done so far?
• What's the current build of your computer? Press Windows key + R and then type winver.
• Did you try to run a full system scan using your anti-virus? Can you tell us the result?
• Does your SD card has a write protection?

Meanwhile, you may try these troubleshooting steps:

Step 1: Run the Hardware and Devices troubleshooter. Open Settings> Update & Security> Troubleshoot> Hardware and Devices> Run the troubleshooter.

Step 2: Check SD Card in Disk Management.

1. Open Disk Management.
2. Your SD card will appear as a removable disk.
3. Check if it has a drive letter.
4. If it does not show anything, right click the SD card and then select “Change Drive Letter and Paths”.
5. Click “Add” and select a drive letter, then click “OK”.

Step 3: Update SD card driver.

1. Open Device manager.
2. Find your SD card and right click it.
3. Select Properties.
4. Click the driver tab and then select Update Driver.

Note: You may need to use a keyboard and mouse to connect to your laptop to perform the said steps if it does not allow on tablet mode.

 

Disk management console view is not up-to-date

i dont know how to fix your disk management, but i can fix your partition problems...




open up Command Prompt with admin rights. (Right click, run as admin)


enter in
DISKPART
list disk

then find the Disk number for your Raid array... lets call it number 7 ( you can tell what disk is what by the total size)
type in

Select Disk 7
List Partition (will give you a list of all the partitions..)
Select Partition 1 (im assuming you only have 1 partition on Disk 7) repeat this step if you have more partitions.
ASSIGN


that should get the array up and running ready to use.


EDITED.

any problems, post back ^^


Still EDITING *Stick Out Tongue

side question, have you tried restarting the PC?