Windows 10: Setting up hyper threading

Is it possible to enable hyper threading on Intel processors only in games? And in idle time it was turned off

:)

 

Can't Enable Hyper-V in Windows 10 Professional

Hi,



Thank you for writing to Microsoft Community Forums.



I appreciate your effort on this. As per my research the error code 0x800f0831 is generated when .Net Framework 3.5 is not enabled on the computer. I suggest you to try enabling .Net Framework 3.5 on the computer. Follow the steps mentioned below:

1. Press Windows key + R, to open
   Run dialog box.
   
2. Type appwiz.cpl and click on
   OK.
   
3. Click on Turn Windows features on or off.
   
4. Now, select the check box for .Net Framework 3.5 and click on
   OK.
   
5. Restart the computer.
   

You can also check if Virtualization feature is enabled in BIOS or not, if it is not enabled, I suggest you to enable it.



You may also refer the troubleshooting steps performed by Jins Peter replied on August 13, 2019 in the thread

Hyper-V on Windows Pro wont install and see if that helps.



For additional information, you may also refer the article
Step-By-Step: Enabling Hyper-V for use on Windows 10.



Disclaimer: Modifying BIOS/ complementary metal oxide semiconductor (CMOS) settings incorrectly can cause serious problems that may prevent your computer from booting properly. Microsoft cannot guarantee
that any problems resulting from the configuring of BIOS/CMOS settings can be solved. Modifications of the settings are at your own risk.



If the issue persists, I would suggest you to post your query in
TechNet forums, where we have support professionals who are well equipped with the knowledge on Hyper-V to assist you with the appropriate details.




Regards,

Nikhar Khare

Microsoft Community - Moderator

 

Even after Uninstalling Hyper-V - msinfo32 shows "A hypervisor has been detected"

Hi,

To address your concern, we suggest that you disable the Hyper V services. Kindly follow the steps below:

• Type Services on the search bar.
• Right click one Hyper V service, then select Properties.
• On Startup type, choose Disabled.
  
  
• You have to disable all the Hyper V services one at a time by following the same steps.

If the issue persists, we suggest that you check out your post on TechNet (IT Pro’s) to make sure you get better answer.



Let us know if you need further assistance.

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.