Windows 10: SNMP not running

Hi All, does anyone know how to solve this kind of error:- Server status Not Start, Restart, Pause and Resume- Failed to Read a Registry key. this may be due to lack of resources. try closing other windows applications to fix the problemthank you

:)

 

SNMP help

The issue with polling from WAN is that the router will not know what to do with the incoming connection requesting the SNMP traps. Sure you could port forward the SNMP port from WAN to LAN but the network monitoring is probably IP based and on a private subnet (IS 192.168.1.x/24) and still at the point the router would not know what to send it too once it has entered. You could do a rule to port forward each IP individually with a virtual WAN port that translates to an IP and SNMP port on the LAN side but would take time if you have MANY devices. I would just suggest doing a IPSEC vpn tunnel between the off site router to the router on site.

 

SNMP help

I had tried previously to run the monitor internally on a server and just poll the devices directly over VPN which worked but the polling internval or traffic from the devices must have been too high because its caused outages network and site wide. Maybe I will look into it again and see if I misconfigured something previously.

Thanks.

 

Is the "SNMP Service" unavailable in Windows 10?

Adding the SMTP service to a Windows OS seems quite straightforward in almost all cases: open the Windows Features interface, then check the "Simple Network Management Protocol" option. After rebooting, a new local service should be available called "SNMP Service".

I've followed those steps in Windows 10 Pro 64-bit, but I find that there is no "SNMP Service" to be found. There is an "SNMP Trap" service, but that's apparently not what I'm looking for. It seems the SNMP agent settings (eg. community name) can only be modified within the properties of "SNMP Service".

In my searching, I found a Powershell command purported to install the SNMP service:

However, the result is an error message (even when run as Administrator):

The words "client-based operating system" suggests the SNMP service is only available for Windows Server OSes, but that wasn't true for Windows 7/8. So I'm curious whether this has changed with Windows 10.