Windows 10: So I got this computer set it up and when I tried to reset it i get this error

Insert your Windows installation or recovery media and restart your computer with this media I have no idea what is talking about and what I'm supposed to do?

:)

 

One computer cannot access other network computers.


So I've tried every troubleshooting step I know:

• Double checked that Net Bios was enabled
• Ran a bunch of network commands:
  • flushed DNS
  • registered dns
  • pinged and located the named computers successfully
• Reset my router to factory settings

Nothing works when I try to access via explorer. I'm still baffled by the fact that every other computer can access each other AND access this computer. It's just the outgoing connection from this machine that doesn't work.

Any thoughts?

 

Error: No work available to process

Hmm. Either it's put out errors and WCG is limiting the work units available, or the project list may not be set to supply other WU when one runs out. (if the problem lies here and not on your end)

On the options to your left, if you go into Results Status, select the computer from Device Name and then look through results see if either they were returned late, errors or any other kind of issue that would stop the servers supplying WU from that perspective.

If there are no errors then it's maybe down to your project list. So selecting Device Manager from the left menu and then clicking on the profile assigned to that computer and make sure that it's assigned to receive WU for other projects if they run out.

At least those steps will rule out problems from the WCG end.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".