Windows 10: SSD and D Drive

I have a new PC with a SSD and normal hard drive.


How do I get the default for files (new, explore, save etc) to be to the D Drive. I seem to have ended up with 2 versions and they aren't in syncd

:)

 

D drive

Hi,

Based on the details you have provided us, it appears that there might be some corrupted contents on the said partition. We can also consider that this is caused by a virus.

For us to check if a certain virus is hiding your files, kindly follow the steps below:

• Type Command prompt in the search bar.
• Type-in the following command:
  
  attrib -h -r -s /s /d D:\*.*
• Press Enter to execute the command.

If you think that there is nothing important stored in it, then we suggest that you reformat your D drive so that you can use the free space for important files.

You can follow the steps below to start with the process:

• Click on the File Explorer.
• Select This PC.
• Right-click on your D drive, then click on Format.
• Follow the on-screen process to finish formatting the partition.

Let us know how it goes so that we can further assist you.

 

D Drive

Thank you, RAJU.MSC for your answer. I don’t know if it is necessary to steal/partition drive D or even if I would be comfortable doing that.
It may be easier to just do as DaveM121 suggests and use Drive D for my data and keep the 128 GB ssd drive C for downloads and programs as it is much quicker.
Your thoughts?

 

Cloning to SSD then swapping drive letters


@SamHobbs
What you want done is very simple and can be done in short period of time. Here's my suggestion:
There's 2 modes that Windows can be installed: UEFI and the old legacy MBR. Open Disk Management, look at the disk where your C drive is, if there's a

1. EFI System Partition, your Windows was installed using UEFI.
2. System Reserved partition, your Windows was installed using MBR

Next, Connect your SSD to an available Sata port (no need to format or do anything). Download: Macrium Reflect Free . Install and run. Follow the steps below:

1. From Macrium, click on image this disk under your C drive and save it to either an Internal or External Drive. This will create a single backup image of the whole disk containing your C drive.
2. Again, from Macrium, click on Restore tab and select the image created from step 1, Select your SSD as the destination drive, click Next->Finish
3. Exit Macrium. If your Windows was installed using MBR, Open disk management and make sure the SSD is marked "Active" else go to next step.
4. Shutdown your PC. Disconnect the HD containing Windows C drive then connect your SSD to it.
5. Reboot. Your PC should boot and the Windows should have C as the drive letter.

NOTE: The procedure above is to backup your Windows to an image file then copy it back to the SSD. This ensures proper cluster size aligment for the SSD. In addition, Macrium also perform Trimming for the SSD. This is more preferable than cloning.