Windows 10: ssd drive

I formatted my ssd drive from my laptop and installed linux mint 19 last week... SO, now i decided to install windows 10 now; so i bought windows 10 pr dvd 2 days ago but when i tried to install windows 10 and it said it cant because


drive 0 partition 1 total size 18630 partition 1 ,,, my ssd drive is not formatted to nfts




free space 0.0 type system


windows cant be installed on drive 0 partition 1

:)

 

Cloning to SSD then swapping drive letters


@SamHobbs
What you want done is very simple and can be done in short period of time. Here's my suggestion:
There's 2 modes that Windows can be installed: UEFI and the old legacy MBR. Open Disk Management, look at the disk where your C drive is, if there's a

1. EFI System Partition, your Windows was installed using UEFI.
2. System Reserved partition, your Windows was installed using MBR

Next, Connect your SSD to an available Sata port (no need to format or do anything). Download: Macrium Reflect Free . Install and run. Follow the steps below:

1. From Macrium, click on image this disk under your C drive and save it to either an Internal or External Drive. This will create a single backup image of the whole disk containing your C drive.
2. Again, from Macrium, click on Restore tab and select the image created from step 1, Select your SSD as the destination drive, click Next->Finish
3. Exit Macrium. If your Windows was installed using MBR, Open disk management and make sure the SSD is marked "Active" else go to next step.
4. Shutdown your PC. Disconnect the HD containing Windows C drive then connect your SSD to it.
5. Reboot. Your PC should boot and the Windows should have C as the drive letter.

NOTE: The procedure above is to backup your Windows to an image file then copy it back to the SSD. This ensures proper cluster size aligment for the SSD. In addition, Macrium also perform Trimming for the SSD. This is more preferable than cloning.

 

Upgrading HP SSD drive on HP 750-524

I purchased an HP Envy tower with a 128Gb SSD which is where Windows is installed, I have purchased a new 1TB SSD drive that I would like to replace the 128 GB drive with. My machine did not come with the Windows 10 Media, what steps do I need to take before
I install the new drive and install windows.

• Where do I get the Windows 10 install
• What steps are needed to create an Install disk
• Do I have to deactivate my old install before removing the old drive.

Please let me know if there are any other considerations.

Best Regards,

Wes

 

Installing an SSD drive on my desktop to use as the C bootup drive

What are you talking about, I have Samsung 830 for 5 years and its still running great there is no issue with NTFS and SSD

To the OP all you have to do is use Macrium Reflect to clone your disk to your SSD you'll have to option to shrink your C partition before you start the actual clone check out this video
it walks you through step by step