Windows 10: Standard Hardware Security Not Supported

Everything was working fine until I reset my pc. In fact, I even had support for enhanced hardware security. TPM2.0 and SecureBoot is enabled. Virtualization features are enabled. No other setting in my bios is related to the requirements, and yet it's saying it's no longer supported. Why?

:)

 

Standard Hardware Security not supported

Hi Paul,

Thank you for writing to Microsoft Community Forums.

We would suggest you to follow the steps mentioned below to run hardware troubleshooter and let us know if that helps.

Type "Troubleshooting" in the
Windows Search bar and press Enter.

1. Click on "View All" in the top left corner.
2. This will display the list of troubleshooters which are built-in in the computer. You can click on Hardware and Devices from the list and you can run the troubleshooter.

Also I would suggest to check if there are any update pending with regard to drivers and to do so, please follow steps mentioned below.

1. Search for Device Manager in
   Windows search bar.
2. Click on Device Manager.
3. Check if there Yellow Exclamation Point in the list of drivers.

Make sure Windows is up to date.

Hope it helps.

Manjunath H

Microsoft Community – Moderator

 

Standard hardware security not supported

I'm replying to Jetta48's post since I'm building off of his reference, which is where I got the original information I used as the basis for my own facetious rant above. Reviewing the section related to Standard Hardware Security:

At the bottom of the Device security screen, one of the following messages will appear indicating the security capability of your device:

Your device meets the requirements for standard hardware security
This means your device supports memory integrity and core isolation and also has:

• TPM 2.0 (also referred to as your security processor)
• Secure boot enabled
• DEP
• UEFI MAT

As most PC systems built since the time of at least Vista and most probably during the later period of the WinXP era would contain hardware DEP and Secure boot was often enabled on higher-end systems even with Windows 8, these typically wouldn't be involved
in the display of this message for recent systems.

However, since both the TPM 2.0 and UEFI MAT hardware (really firmware) requirements are relatively new, either and often both of these might be involved on any system such as Jetta48's, since only the newest models might typically include these.

While looking for some of this info, I found the following Microsoft Docs article that provides some additional detail for these and other

Standards for a highly secure Windows 10 device.

Both the TPM and UEFI MAT are either described or include a reference to other documentation in their respective hardware or firmware sections.

Rob

 

Device Security - Standard hardware security not supported

motherboard should support UEFI , cpu with VT , and TPM , otherwise Standard hardware security not supported will be displayed

so enable UEFI in BIOS , enable TPM in bios , enable intel VT in bios

for more information

Windows 10 Secured-core PCs

Secure boot