Windows 10: start up error

Store Exception Error on Start up

:)

 

Error: No work available to process

Hmm. Either it's put out errors and WCG is limiting the work units available, or the project list may not be set to supply other WU when one runs out. (if the problem lies here and not on your end)

On the options to your left, if you go into Results Status, select the computer from Device Name and then look through results see if either they were returned late, errors or any other kind of issue that would stop the servers supplying WU from that perspective.

If there are no errors then it's maybe down to your project list. So selecting Device Manager from the left menu and then clicking on the profile assigned to that computer and make sure that it's assigned to receive WU for other projects if they run out.

At least those steps will rule out problems from the WCG end.

 

EVGA GTX 2xx series Reinbursement Service

XFX started it and Evga is doing the same. Evga is starting its own reinbursement program for those who bought the Evga 2xx series when they first came out. All you have to do is follow a few steps.

• Must be a new purchase from an authorized EVGA reseller. Step-ups do not qualify.
• You have 14 days to register and upload a qualified invoice to claim your EVGA Bucks.
• Only customers who purhased the EVGA GTX 280 or GTX 260 at the full Manufactured Suggested Reatil Price (MSRP) will qualify for the Reimbursement Program.
• If between June 16th and July 7th you purchased an:

• EVGA GTX 260 you will receive $75.00 in EVGA Bucks* or $60.00 Cash Back
• EVGA GTX 280 you will receive $150.00 in EVGA Bucks* or $125.00 Cash Back

The only thing this doesn't cover is the Step-up program. I'm fine with that because I got the price cut anyway. I just hope to get the card by this weekend if not early next week. I have a itch to bench. *Rockout :rockout:

Source: EVGA

 

Unable to boot; 0xc000000f error on start


@axe0 - No, there was no file mentioned, although the error code remained the same. After I used the bootsec.exe /nt60 command the File: boot/bcd line appeared, which can be seen in the photos.
@zbook - I'll try what you have suggested and post the results. As for the assigned drive letters, no I don't know why they already have assigned letters. As far as I can recall, those were in fact the drive letters they were assigned when the computer was working, but I didn't reassign them during the troubleshooting process. The steps I had already taken are listed in the original post. I had tried to rebuild the BCD previously, but with the same results (i.e. didn't have access, system not found etc.)