Windows 10: Stop Code Error

Hi,

I was recently updating and removing programs from Windows 10. after completing them successfully I restarted the PC as requested. I then received a blue screen that gave me a Stop Code D:\windows\system32\srt\srtrail.txt. I tried all repair functions and going back to an earlier point but the repair does not work and I keep getting the same message. I tried using the command prompt but it shows the drive as X:\ and not C:\.

any suggestions?

Thank You

:)

 

BIOS error codes

So I have motherboard with installed small LED screen, which presents BIOS error codes.

Where can I find a list of those errors. And I don't mean beep codes, but the "number" codes.

Ex after installing sound card, the motherboard startup fails with the code 15.

Example picture of code is here.

 

STOP CODE error


I have analysed the crash dump file and the automated analysis of WinDBG indicates the Malwarebytes driver (MbamChameleon.sys) is the likely cause.

Code:

Code:

BugCheck 7F, {8, ffffba00d0c58f50, fffffd8eedc5c000, fffff8005535011c}    *** WARNING: Unable to verify timestamp for MbamChameleon.sys  *** ERROR: Module load completed but symbols could not be loaded for MbamChameleon.sys  *** WARNING: Unable to verify timestamp for epp.sys  *** ERROR: Module load completed but symbols could not be loaded for epp.sys  *** WARNING: Unable to verify checksum for win32k.sys  Probably caused by : MbamChameleon.sys ( MbamChameleon+76af )

epp.sys is your other EMISoft anti-malware driver so my suggestion would be to remove these anti-malware packages and use Windows Defender. See if this stops the BSOD. If it does you can then try adding back just one of the anti-malware packages and try again.

 

win 10 pro 64 stop code 0x0000007b 0xffffffffc0000034


The STOP 0x0000007B errors are caused by device driver problems, viruses, data corruption, and sometimes even hardware failures. You have tried update your drivers. If the problem still persist, try the steps:

• Run chkdsk on your hard drive. ...
• Perform an extensive test of your hard drive. ...
• Run the fixmbr command to create a new master boot record. ...
• Clear the CMOS. ...
• Update your BIOS. ...
• Update the hard drive controller's firmware if possible. ...
• Repair your Windows installation. ...
• Perform basic STOP error troubleshooting.