Windows 10: Stop code when trying to run Madcatz software for Saitek Flight Yoke

I cant get my flight yoke hat switch to work since buying a new computer. When i try to add the drivers from Matcatz for the 64 bit o.s. , I get the stop code and the computer reboots.

here is the mini dump code. I am running Windows 10 home on a CUK gaming computer with 32 gb of ram and a 208 super graphics card.

I need help. I am not a computer wiz.

Scott Leiser

:)

 

Saitek pro Flight Yoke + Windows 10


Hi bachian,

I have encountered exactly same incident as yours, and I noticed it might be caused by recent Windows 10 update (TH2) whichinitialized some device drivers, such as Saitek Pro Flight Yoke of ours.

So, what I did are as follows;
1. Run "Installer CD" which wasinitially bundled with Flight Yoke.
2. The above installer will also stuck atthe timing to plug the yoke into the USB port as you/we experienced, and thenpress "cancel" to quit the installer.
3. After above operation, the followingfolder has been created, in which driver files are extracted.
c:/windows/temp/Saitek/Saitek_Pro_Flight_Yoke_SD6_64_Drivers
4. Open "device manager", andselect Flight Yoke which would be shown as "unknown device", andselect "renew driver" designating above folder, then PC can recognizeFlight Yoke, now.
5. Then, run "installer for Windows10" downloaded from Saitek official web site, and which will run properlyand terminate successfully.

Hope this will be some help for yoursolution.
Thanks,

 

Saitek, again


I have read all the tips about installing my Saitek Flight Yoke in Win 10 (and P3D), but my yoke doesn´t even show up in the device manager. Installer from Saitek stops where the yoke shall be conneced but nothing happens when I do.

Jack
the Swede in Spain

 

Saitek pro Flight Yoke + Windows 10


Hi,

I just mounted a brand new computer. A nice rig, with the best a could find on the market. My intention is to primarily use this computer for flight simulation and training purposes.

I have the Saitek Pro Flight Yoke, witch I have been using on my old computer running Windows XP for 6 years. But when I plugged into my new computer, it never recognizes it after the computer initialization, so I had I physically disconnect and reconnect it to the USB port. So I decided to go to saitek.com and download the latest yoke drivers.

After that, the problem got worse. The yoke are not recognizable anymore. When I tried to reinstall the drivers, It didn't work, since in the middle of the installation, it requires me to plug the yoke in the USB, but as it does not recognizes it, it does not let proceed with the installation.

I have tried several things to isolate the problem. I plugged the yoke in all other USB ports, 2.0 and 3.0 (witch works fine with other peripherals), tested back on my old pc (and it´s working fine there) and clean the registry and try to reinstall the driver again.

I'm almost sure it's something related to Windows, as during the computer initialization, the yoke lights turn on until Windows are up.

I don't know what else to do. Anyone has some insight?