Windows 10: Stuck at Version 1803

I successfully Upgraded to Version 1803 on 5/21/2018 and am receiving all updates just fine. A couple of weeks ago there was a message in Windows Update that said Version 1803 reaches end of life in September 2019. I clicked on Check for Updates and it says I am up to date. What is the next Version and how do I get it?

:)

 

Unable to update Windows 10 Pro version 1709 to 1803

Have made several attempts to update Windows 10 version 1709 to the latest version 1803 and have not been successful.

I've done the following per some suggestions found online:

• Updated drivers
• Ran the Trouble Shooter for Windows 10 (Errors found were shown to be "Fixed" per the tool)
• Unplugged the printer

Although not at every attempt, I have received the following errors:

• 0xc1900101
• 0x80070643

Can someone please advise me as to what the errors are and provide me with the steps to update Windows.

Thank you.

 

windows 10 version 1803 welcome screen?

Hello Jim,

The Windows Welcome experience will only be shown after installation of updates and occasionally when you sign in to highlight what's new and suggested by design. For more information about the new features and content of Windows 10 1803, please refer to
these support articles. It also includes a video that summarizes the new content in this release:

• What's new in Windows 10, version 1803 IT Pro content
• What's new in Windows 10, version 1803

Also, make sure that the Windows welcome experience is enabled on your PC. Follow the steps below:

1. Open Settings > System > Notifications & actions.
2. Under Notifications, toggle the switch On "Show me the Windows welcome experience after updates and occasionally when I sign in to highlight what's new and suggested".

Hope this information helps, feel free to post back if you need further assistance.

 

Stuck in Windows 10 Upgrade

My computer seems to be stuck in a Windows 10 failed upgrade loop. I was running fine on a beta version of Windows 10, and then I came downstairs one morning to see it repeatedly booting, attempting to repair, then rebooting. The steps I've taken to diagnose are:

• Attempting to boot off a USB drive (with all drives disabled in BIOS) - this fails at the point of the blue windows screen
  
• Attempting to boot the machine itself and getting into "repair/safe mode" using F7
  
• Looking at the BIOS for obvious failures (e.g. RAM that should be there is missing) - nothing obvious is wrong.
  

I am fairly certain the build version was 9926. For many months, the system would attempt to upgrade, and then say "it failed" for some reason and roll back.

Suggestions for next steps?