Windows 10: Unable to format USB Drive

When i am trying to format the usb drive it shows me windows was unable to format the drive . I tried all methods but it not working.Also happens in copy and paste also.When i am trying to copy a file pc to usb drive it shows me"Destination folder access Denied". I am the Administrator.But in the pc copy and paste working properly.Problem with not my usb drive, it shows all external drives the same error.

:)

 

USB Flash Drive saying not formatted..?

Hi,

I have a Memorex Poker Chip USB Flash Drive 1GB, and It shows up fine on one PC as "Poker Chip" in explore, and I can transfer files... but on my other PC (the one I'm on now..specs in profile) it's listed only as H: Removable Disk, and when I click on it, it says: "The Device is not formatted, would you like to format it now? (Y/N). Why would it be recognized on one PC, but the not the other? How come the other PC didn't need it formatted? When I click yes to format it, it says: "Windows was unable to complete the format"

I went to the BIOS and USB 2.0 is enabled. And Device Manager does list it as a Memorex Poker Chip..

 

Unable to format USB drive in Windows 10

IF windows are not able to format USB drive then apply these manual steps as follows:
First open run command box > Now, write diskpart and hit enter > Once
Diskpart is open > Now writing the commands, one by one.
Command 1: List disk
[Now, it will list Disk 0 and Disk 1 in your PC. Clearly Disk 0 is your hard disk and Disk 1 is the USB flash drive.]
Now, write the commands given below One by One.
Command 2: Select disk
Command 3: clean
Command 4: create partition primary
Command 5: active
Command 6: select partition 1
Command 7: format fs=fat32
[In the above command fat32 is chosen as a file system, if you want to choose NTFS, you can choose that as well.]
It will take time. Do not close the window before it's completed.
This manual steps may help you to format the drive. Thanks

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!