Windows 10: Unsigned driver

I have Veikk v50 graphic tablet. When installed it all works fine apart from the pen pressure. Looking in device...... It shows with the alert sign and the unsigned message. I can go through recovery etc and switch off the block on unsigned drivers, install the driver and it all works fine but if I switch off the computer I have to go through the whole farce again. HELP

:)

 

unsigned drivers

Hi Dyllan,

Since you have tried many troubleshooting methods with no luck, we recommend you to boot Windows 10 with
driver signature enforcement disabled. To do so, kindly follow these steps:

• Restart your PC while holding down Shift.
• On the Choose an option screen, select Troubleshoot.
• Select Advanced options and click Startup Settings.
• Click Restart to restart your PC into the Startup Settings screen.
• Press 7 or F7 at the Startup Settings screen to activate
  Disable driver signature enforcement mode.
• Driver signature enforcement is now disabled and it will remain disabled until you enable it back on the
  Advance boot option.

Let us know if this enables you to install unsigned drivers.

Regards.

 

Trying to Install Unsigned Driver for DJI Flight Controller on USB


You might try this:

Installing Unsigned Drivers by Disabling Integrity Checks
To disable integrity checks:
STEP 1: Open the Command Prompt as admin from the Power User menu, then execute the command: bcdedit /set nointegritychecks off
STEP 2: After executing the command, restart your PC, and then proceed in installing the unsigned driver for your system.
STEP 3: To re-enable integrity check, execute the below command as an admin in the command prompt: bcdedit /set nointegritychecks on
STEP 4: When you get the message saying the operation was successful, restart your system and you’re good to go.

 

How to install an unsigned driver


Cannot remember exact menu as not at pc, but its via the troubleshooting menu in recovery and updates. Somewhere an advanced option to restart pc, then it gives a list of options and one is to restart with unsigned drivers.