Windows 10: Update or do not update

I am seeing two updates from the Intel page of the following listed below however when I go to download them Microsoft has its popup stating the updates are not accepted by Microsoft and I am left with a decision of deciding to update anyway and run the risk of causing issues.Here are the two updates on the Intel that are available for downloading.BT-22.250.0-64UWDBT-22.200.032 UWDVery confusing and frustrating the way things are set up.Kenneth

:)

 

Intel Readies P55 Chipset B3 Stepping Update

Intel's is readying a hardware update for its P55 Express chipset, currently the only core-logic for the company's brand new socket LGA-1156 processor platform. The new B3 stepping of the P55 PCH will bring with it a little more than new MM number and S-spec numbers. A list of changes is as follows:

• New MM number and S-spec numbers for the converted products;
• Firmware and minor BIOS updates are required with the conversion;
• Processor MRC/microcode update required to enable future processors;
• Recommended storage driver upgrade from Intel MSM 8.9 to Intel RST 9.5.

Although it is listed that the MRC update enables 'future processors', Intel, in a statement issued to X-bit labs assured that the current B2 stepping of the chipset (found on current socket LGA-1156 motherboards) does not leave out support for any of Intel's new LGA-1156 processors that are slated for release in the very near future. The dual-core "Clarkale" 32 nm processor will be supported by both B2 and B3 steppings of the chipset.

P55 B3 stepping is pin-identical to P55 B2, and hence motherboard vendors will not have to come up with new designs. Sampling of the new stepping began as early as on October 02, 2009, and it is scheduled for shipment to manufacturers by the 7th of December, 2009. P55 is the performance core-logic for the LGA-1156 platform. It supports Core i5 and Core i7 "Lynnfield" processors with discrete graphics.

Source: X-bit labs

 

Intel E5200 Gets Updated, R0 Stepping Coming Up

Intel's Pentium Dual-Core E5200 processor is getting on course for a specifications update. The chip will feature in a new, improved Wolfdale-2M core, spec'd out as the R0 stepping, from its current M0 stepping. The new stepping is intended to add new instructions, power-management features, and bring about changes in the chip-package. A short list of known changes is as follows:

• CPUID changed from 10677 to 1067A
• Power State Indicator (PSI) support with Intel 4 series chipsets
• New instructions - XSAVE and XRSTOR
• New S-spec and MM numbers
• New halide-free chip package

Due to the changed CPUID, users may require BIOS updates to detect the CPU. According to the company, E5200 R0 should be out by April 13.

Source: TechConnect Magazine

 

Should I update bios?

I would read the warranty before doing anything. If the manufacturer finds out you did something not on their approved list of steps,for example using a program they didn't list, or a bios, etc, they can treat your video card rma like you threw it against the wall , because if something goes wrong and you didn't follow their steps exactly ,it was damaged through human error and they're not likely going to be obligated to cover it warranty wise. I don't know for sure, I just advocate that you check first , and I also advocate that you verify that it's an actual update ,because very rarely do manufacturers release updates for gpu bios'. And they most certainly wont cover a GPU "update" if its a bios file written by some dude in the Ukraine, it has to be a set process, they have predetermined often.