Windows 10: Updates Pending to Installed

How do I get from Pending to Installed when new updates have completed the download?

:)

 

Insurgency wont install and run for me....

I have played and have fully updated CS and Half life 2....
I am using the newest client and installed the SDK.

I am completely blown away, if i click the desktop icon it starts the sdk and then closes, and it doesn't show up in my game list...

First mod attempt install here, followed the directions step by step on the mods website...

Any ideas?

 

Windows Updated(16299.309).KB4088776 Restart is required to complete.


Hi dalchina. Good news, I followed your suggestion and reinstalled the update and now it appears as "installed correctly" *Biggrin Maybe it was not necessary to run the Windows Update Troubleshooter or maybe if necessary. But using it I do not think it could have worsened something. The installation was very fast, unlike the first time it showed step 1 and step 2 completed.

Thanks for the suggestions and for the time to respond Best regards.


And thanks for the tip of that program, I'll have it on my list.

 

Unable to install pending updates after upgrading to Windows 10

Hi Paro,

Apologize for the delay in response to your issue.

As the above troubleshooting steps couldn't resolve the issue to install pending updates, let us try the below and check if it helps.

I suggest you to rename SoftwareDistribution folder and check if it helps.

Step 1: Stop BITS, Cryptographic, MSI Installer and the Windows Update Services.

• 
  Press Windows Key + X on the keyboard.
  
• 
  Select Command Prompt (Admin) from the menu.
  
• Type the following commands at a command prompt. Press ENTER key after each command.

• net stop wuauserv
• net stop cryptSvc
• net stop bits
• net stop msiserver

Step 2: Rename SoftwareDistribution folder.

• Press Windows key + X key on the keyboard.
• Click on Command Prompt (Admin).
• Type net stop wuauserv and press Enter.
• Type rename c:\windows\SoftwareDistribution softwaredistribution.old
  and press enter
• Type net start wuauserv and press Enter.
• Type exit and press Enter

Step 3: Start BITS, Cryptographic, MSI Installer and the Windows Update Services

• 
  Type the following commands in the Command Prompt.
  
• 
  Press the ENTER key each command.
  

• net start wuauserv
• net start cryptSvc
• net start bits
• net start msiserver

3. Type Exit in the Command Prompt to close

4. Restart the computer.

Hope it helps. Get back to us with an updated status of this issue for further assistance.

Thank you.