Windows 10: What is the "Surface - Keyboard 1.0.104.0" Driver?

Running v1909 on the first system in my specs.
Keyboard: Microsoft KC-0405 - wired.

Windows Update is nagging me to install the Surface - Keyboard 1.0.104.0 Driver.
Now I checked and this driver seems to be for a wireless keyboard filter, but I could be wrong.

I went into Device Manager and selected my wired keyboard and updated the driver from there.
This changed the device from "Keyboard" to "Wireless Keyboard Device Filter".
On restart there was an unknown device listed with the yellow bang and it was the wireless keyboard device filter.
Did a restore point and everything back to normal.

I used the Windows Update hide-show troubleshooter to try and hide the update. Didn't work. The update persists.

Looking for thoughts on what this driver is, and why Windows is offering a driver for a device I do not have.

:)

 

changed reg from 0 to 1

i followed all steps and wmware15 still woudnt start. i've changed the registry from 0 to 1 and worked like a charm

 

Raid 0 help

Hi all, I've followed the IRST raid installation directions and I have created myself a Raid 0 volume. Rapid storage confirms my successful migration from a system disc to a raid 0 array. I'm also able to select it as my boot device in BIOS, but what I don't understand is why it is not listed in my Drives under my computer

In fact, my computer still lists my original C: drive with the original capacity. I feel as if I've miss an important step here and I'm unsure how to proceed.

 

System Reserved Partition on Disk 1 not Disk 0

The results were the same as before: Windows is installed in a single 477 GB partition on Disk 0 and the System Reserved is in a 500 MB partition on Drive 1. The rest of Drive 1 is unallocated. This is identical to the configuration I had when I asked the
question.

The Media Creation Tool used to created the install ISO DVD is v. 10.0.14393 downloaded on 12/13/2016.

I followed your instructions:

• I selected Drive 0 and deleted the existing Windows partition.
• I clicked New and Apply. Windows then formatted Drive 0 as a single primary partition.
• The existing System Reserved partition was still on Drive 1.
• So I deleted the System Reserved partition on Drive 1 and the just created Primary partition on Drive 0
• I then selected Drive 0 and clicked New and Apply again. Same result a single Primary partition on Drive 0. Drive 1 was left unallocated.
• Upon completion of the install
  • Windows occupies about 15 GB in the only partition on Drive 0
  • The 500 MB System Reserved partition was placed on Drive 1
  • The rest of Drive 1 is unallocated.

How can I get the System Reserved partition to be placed as the Partition 1 on Drive 0 with Windows installed in Partition 2?

Thanks.

Bill