Windows 10: When I click this, I am presented with "there was a problem resetting this pc"

Good afternoon,


I purchased a new ssd and placed into the correct port on the motherboard.


When I turned the PC on, it presented the Critical Error screen.


After consulting a few in the know people I decided on a reset in the trouble shooting options.


When I click this, I am presented with "there was a problem resetting this pc"


I'm not very well versed in computers so I'm reaching out for help!


Thank you

:)

 

router logs DoS attack from a local PC....

Well you did not say that you don't really know what you are doing. It's not a problem of course, but it changes things a little.

It's not even clear if the PC or the router is the problem at this time, so I suggested that you disable some unnecessary things which are usually known to cause many problems, sorry if those were too complicated.

• You could reset some network related stuffz on the PC as a next step. Open an elevated command prompt (run as administrator), and enter the followings on the PC:
  netsh int ip reset reset.log
  netsh int ipv6 reset
  netsh winsock reset
  netsh branchcache reset
  netsh advfirewall reset
  (note: You can export your current firewall rules in the "group policy" before the reset if it's needed for some reason)
  
  
• Btw, Would it be a problem to reset the router to the default settings if the things we are trying will not help? There is a menu point for that called "factory settings" (and also a little hole on the back if you prefer that one).. the Administrator username in the router after the reset would be admin and the password is probably on a sticker at the bottom of the router (special settings needed to go online with your ISP might be also necessary)
  This is not needed now (not yet), but perhaps the source of the problem is at the router and not the PC in question, so we may come to that eventually.

ps.: Do you have a second network card you could test in that PC and a different cable to rule out some hardware issues on the PC side?

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

No Battery present but 100% charged?

Hi Jennifer,

As per your description it seems like you couldn't find the power option. I suggest you to try the below and see if it helps.

• In search type troubleshooting and hit enter.
• On the left pane click on View All.
• Now from the list of troubleshoot select Power and follow the onscreen instructions to run.

Please be informed that, the steps given in the method 2 is just to reset the power plan settings. It won't reset the whole system. So, I suggest you to try the steps and check if it helps.

Thank You.