Windows 10: why do you continue to invade my PC and break it all the time? Ever consider testing. about...

almost daily now you are in my computer breaking something else. if you're too stupid to properly test, clue the end users are not your testers, you might be welcome. today you broke the connectipn to onedrive. how stupid can you morons get?

:)

 

PC Build Steps

Ok just because I like steps i am going to create some steps. Please give me the stamp of approval/disapproval

• Install system in case
  • Remember to connect SSD and optical to same SATA ports on motherboard
• Turn on PC
• setup HDD
• run blend test in prime95 for 30-60 min
  • run realtemp at the same time

• While in Prime95 test
  • if CPU goes above 70c in RealTemp, I have a leaky CPU
  • if my system locks up or blue screens, there is an instability in the system somewhere
  • if my system does not lock up or blue screen, my CPU is not damaged and I am in the clear!

What do you guys think??

 

Overclocking / Undervolting guide for Vega 56 or 64?

Here's a quick laundry list:

List of software to use for overclocking and testing
Examples:
Wattman (and how to find and use it, like an overview, including profiles)
Unigine Valley or Heaven (use this for quick testing while changing settings in Wattman and checking for stability / artifacts) ...just suggesting this
How to monitor cores / mem speeds and temps during testing (I've seen screen overlays, and others using GPUz)

Step-by step overclocking in Wattman
Fan speeds
Power limit
Temp limit
Voltages
Core speeds
Memory speeds

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".