Windows 10: Why does Netstat 127.0.0.1 "Can not obtain ownership information"

Today I ran a Netstat offline, I have an Active well Time_Wait connection to "Can not obtain ownership information" on a Loopback address. Why would this happen? How can I obtain that information. The process was in the NT Kernal & System. If you know how I could get the IPv6 address to display, I really need that.And when I have it disabled to troubleshoot, why am I seeing it running?C:\WINDOWS\system32>Netstat -a -b -o Active Connections Proto Local Address Foreign Address State TCP 0.0.0.0:135 pcname:0 LISTENINGCan not obtain own

:)

 

changed reg from 0 to 1

i followed all steps and wmware15 still woudnt start. i've changed the registry from 0 to 1 and worked like a charm

 

Raid 0 help

Hi all, I've followed the IRST raid installation directions and I have created myself a Raid 0 volume. Rapid storage confirms my successful migration from a system disc to a raid 0 array. I'm also able to select it as my boot device in BIOS, but what I don't understand is why it is not listed in my Drives under my computer

In fact, my computer still lists my original C: drive with the original capacity. I feel as if I've miss an important step here and I'm unsure how to proceed.

 

System Reserved Partition on Disk 1 not Disk 0

The results were the same as before: Windows is installed in a single 477 GB partition on Disk 0 and the System Reserved is in a 500 MB partition on Drive 1. The rest of Drive 1 is unallocated. This is identical to the configuration I had when I asked the
question.

The Media Creation Tool used to created the install ISO DVD is v. 10.0.14393 downloaded on 12/13/2016.

I followed your instructions:

• I selected Drive 0 and deleted the existing Windows partition.
• I clicked New and Apply. Windows then formatted Drive 0 as a single primary partition.
• The existing System Reserved partition was still on Drive 1.
• So I deleted the System Reserved partition on Drive 1 and the just created Primary partition on Drive 0
• I then selected Drive 0 and clicked New and Apply again. Same result a single Primary partition on Drive 0. Drive 1 was left unallocated.
• Upon completion of the install
  • Windows occupies about 15 GB in the only partition on Drive 0
  • The 500 MB System Reserved partition was placed on Drive 1
  • The rest of Drive 1 is unallocated.

How can I get the System Reserved partition to be placed as the Partition 1 on Drive 0 with Windows installed in Partition 2?

Thanks.

Bill