Windows 10: Wifi Adaptor

I have a windows 10 laptop HP that when i plug a USB programming cable in the WIFI adaptor disables. The cable connects to a radio which has an IP address but i have used it fine before with WIFI.

Now its treating the cable like its a ethernet cable.


Thanks


Mike

:)

 

Cannot install Windows 10 due to wifi adaptor

Hi Nigel,

Thank you for posting your response.

As you have stated that your computer is stuck in the splash screen after the first boot, I would suggest that you power down your computer and then restart the system and check. To do so follow the steps below.

• Unplug the charger and remove the battery of your laptop, if using a desktop remove the power cord.
• Press and hold the Power button for 30sec
• Plug the charger/power cord and restart system

if you roll back to the previous Window, you can also try to install the latest drivers for your wifi adaptor and check if it helps you proceed with the installation. The above issue that you are facing is due to the wifi adaptor, and I recommend that
you contact the manufacturer of the device that is Broadcom to check for compatibility.

Hope this helps

 

Wifi adaptor problem


Hi, My wifi adaptor suddenly stopped working, but I can connect to internet with Ethernet cable.
Replaced wifi adaptor but still cannot to internet with same.............any ideas?
Regards,
John P.

 

USB WiFi adaptor

Ah yes, the famous Windows 10 USB WIFI adaptor driver issue. You could try unzipping the drivers and from device manager selecting "have disk" and pointing to the inf file. But I have my doubts for success from posts like this:





F5D8053N - Windows 10 - Belkin Community

I currently have a desktop MB that has wifi on the chip and this solved my USB wifi problems once and for all. You can check this thread when I had a similar problem (post 15).
Solved USB Wi-Fi adapter not showing on tray - Page 2 - Windows 10 Forums

The D Link DWA-182 firmware C worked for me in Windows 10. You have to make sure you have the revision C model (not A). However, even with that there were issues. Windows 10 recognized it as the realtek (chip) drivers. To get the D link drivers showing up (and working) in Windows 10 I had to extract the drivers and point to them in device manager. Then they installed and I didn't have disconnect issues after that (well, most of the time).

You could try this D Link one but make sure your store has a return policy just in case. Otherwise I would suggest a search on all the adaptor manufacturers (Asus, etc) to see if their model actually has a Windows 10 driver to download. If they don't, good possibility there will be an issue.