Windows 10: Win 10 and Flash

So are Flash updates for IE and non-Chromium Edge completely over? If so then why not just make update which removes Flash from those 2 browsers since near year before death of Flash so many likely vulnerabilities coming up.

:)

 

Recommend hardware changes for upgrading from Win-7 to Win-10

Bree
I followed your suggestions (2nd Aug 19) for installing Win-10. Made the bootable flash drive successfully through the media creation tool. But when I attempted to upgrade and activate to Win-10 (64 bit) from within Win-7 (Pro-32 bit), I got the following error message:

Error # OxC1900101-Ox20017. " The installation failed in the SAFE_OS phase with an error during BOOT operation"

I read the diagnostics under this error number and carried out the proposed fixes, i.e. update Win-7, uninstall Malwarebyte antivirus, disconnect all external hardware, e.g. printer, scanner, external hard drives. I then tried to repeat the steps to do the upgrade through the Win-10 bootable flash drive as before. Got the same error message.
Appreciate any further comments and suggestions as to (a) what does a failure in the SAFE_OS during boot operation mean, (b) what can I do to solve it. Is this anything to do with the hardware in my computer? I listed these in my first posting above.
Thanks for any help

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

How to use Win flash?

there is a way i've found that works, using W1zzard's advice, ill look it up and post it here for you.

EDIT: here it is *Big Grin

USING ATI WINFLASH TO FLASH YOUR BIOS

you have to run it through the command prompt.

Step 1: create a new folder in the root directory of your C drive (so you can easily navigate to it in DOS).

Step 2: copy all the ATI WinFlash files and the new BIOS to this new folder.

Step 3: open command prompt and navigate to your new folder.

Step 4: use the normal ATIFlash command: "atiwinflash -f -p 0 4870.rom"

it should take a minute or two to flash. it will tell you to reboot. you'll have to reinstall your video driver. but everything worked for me after that.

WARNING: if you don't get a successful confirmation at the end of the flash, make sure you flash it again before you reboot. you will brick your card if you reboot before a successful flash.