Windows 10: Win 10 crashed and stopped booting from Dual boot.

Hi, I'm trying to sort out a boot issue with Windows 10 from a Dual boot system. Win 10 had been running fine for about a year and one morning I tried to wake it from sleep mode and it crashed. When the PC failed to reboot I loaded up Win 7 and it wanted to scan my Win 10 drive. There was some error and it did a lot of 'repairing'. Consequent scans shows NO sector or file errors. Can someone look at my DISM log to see if that gives any pointers.

Windows 10 PRO - Not sure what version number sorry.

Code:

Shane

:)

 

dual boot win 10

I had upgraded my old 32 bit win 10 to a 64 bit win 10 system and while I was transferring my files, I dual booted from the original 32 bit Win 10 system. Now that everything is running smoothly, I would like to remove the old 32 bit partition and included
the space in my new 64 bit system. However, when I go into the disk management, it is listing the old 32 bit system as 'system,active,primary' partition and is listing my new 64 bit system as (boot, pagefile, crash dump, primary partiton). I am afraid to make
this partition as active in case I lose all my files. Any suggestion of how to get rid of the 32 bit partition and make the 64 bit system bootable?

Thanks

Key Buster

 

Dual boot problem

Hi all.

I have an older PC that used to run XP. I upgraded it to Win 7 and have now upgraded to Win 10. I now want to make it a dual boot Win 10 system, using the second drive as a disaster recovery backup.

When I set up the dual boot Win XP / Win 7, the system put system boot files on the XP disk. Now I can't boot into Win 10 with that disk off line, nor can I format the XP disk to install Win 10 as it has running system files on it.

I have created a recovery USB flash drive but even after setting the boot devices in BIOS to boot from USB, it will not boot from the recovery disk. My next step is to create a recovery CD to see if that will work.

Any suggestions?

Regards,

Steve

 

Dual Booting with Windows 8.1


The procedure below will allow you to boot Windows separately or in dual boot configuration.
Here's what I recommend to do:

1. Disconnect the drive containing Windows 8.1
2. Install Windows 10 with one drive connected.
3. After step 2, reconnect the drive containing Windows 8.1
4. Boot up Windows 8.1. Open disk management and take a note of the drive letter of Windows 10 OS.
   NOTE: if you boot up Windows 10, then take a note of Windows 8.1 drive letter
5. Open Admin command prompt and type: bcdboot X:\windows where X: is the drive letter of Windows 10 (Windows 8.1 if you boot from Windows 10 in step 4)
6. Reboot the PC. You should have a dual boot screen.

NOTE: To break off the dual boot setting, Win+R->msconfig->boot and delete the none default entry on the list.