Windows 10: Windows 10 Random Reboot Loop before and after Update version 1909

G'day,

My windows version number is now 1909.

I was working on a Word.docx and out of nowhere the PC restarted. Following this I did a Google search and noticed there were posts relating to this issue about Reboot Loop and Windows Updates. I looked in Windows Settings and noticed there were updates pending for version 1909, so I ran the updates thinking this may fix the problem. However, after this I continued to work on my document but the rebooting happened again.

I followed a post which recommended that I go to the MS Download Site created the installation media on a USB and when I rebooted the PC I would get a "Repair your Computer" screen. However this did not work, I didn't get that screen. I have a brand new USB 3.0 with the Media Creation tool on it. I tried to boot from it by going into the BIOS and selecting the USB as 1st priority, but this did not produce any result.

It seems that I may need to make the USB Bootable for this to work. At this stage I'm not sure how to do this, (make the USB bootable). So, at present I need to get to that "Repair your Computer" screen, but I need help in two ways:
1) Making the USB bootable, and 2) Will this Repair screen fix the problem?

My PC I purchased in 2016 and it shipped with Windows 10 Home installed on it, I have not had a problem with it from then to now. Until this rebooting thing began to happen. It hasn't happened now for a couple of hours, perhaps with the number of reboots I have done, could they have fixed it? I would like something like a repair utility to check my system now as to whether it needs repair now? It is hard to know. Is there a repair utility out there? Is that what I need?

Your help would be appreciated Thanks.

:)

 

Windows 10 Random Reboot Loop before and after Update version 1909




-> Download Now - then select from next dialogue from 1 of about 3 locations.

Actually Golden quoted me on that- see my post #4 where I suggested what to look for.

 

Windows 10 Random Reboot Loop before and after Update version 1909

 

Windows 10 Random Reboot Loop before and after Update version 1909

Hi,
I think I should clarify what is happening a bit more carefully. The PC can function OK for a while, half an hour or longer, then it reboots and once again, as I'm doing now it will run again normally. But, at a later time it will reboot unexpectedly. It is NOT stuck in an infinite loop. I guess I wanted to make that clear. Whether that makes any difference to how we approach this I don't know. But thank you for your help so far. I have downloaded HWiNFO64 the previous version I couldn't download the latest version.







- - - Updated - - -

I ran the Windows Memory Diagnostic Tool and it reported everything OK.