Windows 10: Windows 11 doesn't recognise driver for Garmin ANT stick

I have a Garmin device that connects via an ANT stick. Since installing Windows 11 the ANT stick is not recognised when I plug it in. I have contacted Garmin and re-installed the driver, but still nothing. Garmin advised me to contact Microsoft for help.

:)

 

Windows doesn`t start. Authomatic repair doesn`t work.

Thanks again!!

I`m sorry I had not noticed that the text on the picture was in spanish. It says that windows has replaced some damaged clusters in "name" file and "directory". Then, at the end "an unspecified error occurred (75736e6a726e6c2e 4f6)".

I`ll do it and I`ll be updating this thread when I have the report.

- - - Updated - - -

I ran SeaTools. These are the results:




Does it mean my HDD is useless?

 

Garmin Forerunner / Ant stopped uploading since I installed Zune / Windows Phone

I have a Garmin Forerunner cardio monitor which connects (Bluetoott) to a USB stick called an Ant.

The Stick then connects to the Garmin training center which records my training sessions.

Since I installed Zune and connected my Windows phone, the traces start uploading but never finish, and I lost a few as I had the auto-delete after upload set.



Carol

 

Ant+ Stick only works in USB Hub

I have a, in my opinion, strange issue.

I use a Garmin Ant+ stick to collect cycling data while on a stationary trainer. I had purchased a Lenovo Yoga early 2018. It only has 1 usb port so I purchased a 4 port USB hub so I could increase my number of ports a second screen and hardline to ethernet.
I plugged in my Ant+ stick and the computer did not respond. Downloaded all the proper drivers googled the heck out of it and came up empty. I assumed the Ant+ stick some how went bad. I purchased a new one. When I plugged this in, the computer responded,
but it showed the device not recognized (the last USB you plugged in malfunctioned and Windows did not recognize it). Eff.

By sheer frustration, i went to my desk and plugged in my USB hub. I said what the heck and plugged in the Ant+ stick. Would you believe me if I told you that I now have two Ant+ sticks that work completely fine? Has anyone come across this before? Why
does this device work fine when plugged into the USB hub and fails miserably when directly plugged into the USB port? I will admit I had to make some changes to get the USB hub to work, but I can't remember what was done. I've got no problem using the hub
while I train, but I just don't understand what's going on.

Thanks in advance.