Windows 10: Resetting computer after failed updates for past two months

I tried to reset my dell laptop after i hadn’t updated it for the past two months due to failed updates multiple times and it was going good until it got stuck on an “undoing changes” text popped up after it had gotten through two stages of fixing c drive. It has been stuck on this screen for the past hour and ten minutes. I was wondering what do i do because i am unable to completely reset the laptop as it has an AMD Radeon R5 M335 4GB graphic chip in it and it would wipe the chip off the computer’s list of graphic chips so i was wondering again what my possible solutions are.

:)

 

Windows 10 fails to update


When you finish testing the Avast suggestion, make sure that you restart your machine.

Then if the issue persists, please return to the trouble shooting list in post# 89

I think there are three steps that remain; the WU troubleshooter, reset WU components, and manual WU reset.

 

Windows 10 fails to update


Thanks,

The Users list compared to the Profile list you posted earlier tell me there is not an issue with Users (a known issue where there is a profile in the list, but not actual User folder).

The error code suggests corruption in the CBS manifest:
Try these steps one at time until the issue is resolved or you run out of steps.

Is Windows activated?
No? Activate Windows 10

Launch Command Prompt (Admin)
enter the following line
reg query HKLM\Software\Policies\Microsoft\Windows\WindowsUpdate /s
If DisableWindowsUpdateAccess REG_DWORD 0x1

launch regedit
navigate to HKEY_LOCAL_MACHINE\Software\Policies\Microsoft\Windows\WindowsUpdate
change the value of DisableWindowsUpdateAccess to 0
exit regedit
exit Command Prompt

Launch Windows Update

Try the next suggestion if the issue is not resolved.

Restore health to the component store
DISM - Repair Windows 10 Image
Step 6. To Use DISM /RestoreHealth /Source:wim Command
- OR -
Step 7. To Use DISM /RestoreHealth /Source:esd Command
Check System Files
SFC Command - Run in Windows 10
Read the front material, then
follow >> OPTION THREE <<
To Run SFC /SCANNOW Command in Windows 10

If there are integrity issues reported on screen,
Follow the instructions in >> OPTION FIVE <<
To View Only the "SFC" Scan Results from the CBS.LOG

If there are no integrity errors, Launch Windows Update

Try the next suggestion if the issue is not resolved.

Paste the following line into the address bar of File Explorer
Control Panel\All Control Panel Items\TroubleshootingLaunch System and Security > Fix problems with Windows Update
Press Advanced
Select Run as administrator
Press Next

Launch Windows Update

Try the next suggestion if the issue is not resolved.

Automatically reset Windows Update components
Download and run MS Windows Update diagnostic cab (direct download)

Launch Windows Update

Try the next suggestion if the issue is not resolved.

Manually reset Windows Updates via batch file

Windows Update - Reset in Windows 10

Launch Windows Update

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".