Windows 10: Can't reset time for update to run.

If this automatic reply to my request for help, did me no good at all and there was no option to try anything else. Now what?

:)

 

Windows Updated(16299.309).KB4088776 Restart is required to complete.


Hi dalchina. Good news, I followed your suggestion and reinstalled the update and now it appears as "installed correctly" *Biggrin Maybe it was not necessary to run the Windows Update Troubleshooter or maybe if necessary. But using it I do not think it could have worsened something. The installation was very fast, unlike the first time it showed step 1 and step 2 completed.

Thanks for the suggestions and for the time to respond Best regards.


And thanks for the tip of that program, I'll have it on my list.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Windows 10 fails to update


Thanks,

The Users list compared to the Profile list you posted earlier tell me there is not an issue with Users (a known issue where there is a profile in the list, but not actual User folder).

The error code suggests corruption in the CBS manifest:
Try these steps one at time until the issue is resolved or you run out of steps.

Is Windows activated?
No? Activate Windows 10

Launch Command Prompt (Admin)
enter the following line
reg query HKLM\Software\Policies\Microsoft\Windows\WindowsUpdate /s
If DisableWindowsUpdateAccess REG_DWORD 0x1

launch regedit
navigate to HKEY_LOCAL_MACHINE\Software\Policies\Microsoft\Windows\WindowsUpdate
change the value of DisableWindowsUpdateAccess to 0
exit regedit
exit Command Prompt

Launch Windows Update

Try the next suggestion if the issue is not resolved.

Restore health to the component store
DISM - Repair Windows 10 Image
Step 6. To Use DISM /RestoreHealth /Source:wim Command
- OR -
Step 7. To Use DISM /RestoreHealth /Source:esd Command
Check System Files
SFC Command - Run in Windows 10
Read the front material, then
follow >> OPTION THREE <<
To Run SFC /SCANNOW Command in Windows 10

If there are integrity issues reported on screen,
Follow the instructions in >> OPTION FIVE <<
To View Only the "SFC" Scan Results from the CBS.LOG

If there are no integrity errors, Launch Windows Update

Try the next suggestion if the issue is not resolved.

Paste the following line into the address bar of File Explorer
Control Panel\All Control Panel Items\TroubleshootingLaunch System and Security > Fix problems with Windows Update
Press Advanced
Select Run as administrator
Press Next

Launch Windows Update

Try the next suggestion if the issue is not resolved.

Automatically reset Windows Update components
Download and run MS Windows Update diagnostic cab (direct download)

Launch Windows Update

Try the next suggestion if the issue is not resolved.

Manually reset Windows Updates via batch file

Windows Update - Reset in Windows 10

Launch Windows Update